OPERATION
REVERSIBLE
See Figure 4.
This tool has the feature of being reversible. The |
| |
direction of rotation is controlled by a lever located above |
| |
the switch trigger. With your screwdriver held in normal |
| |
operating position, the direction of rotation lever should |
| |
be positioned to the left of the switch for forward driving |
| |
operation. The direction of rotation is in reverse when |
| |
the lever is to the right of the switch. |
| |
The design of the switch will not permit changing the | REVERSE | |
direction of rotation while the screwdriver is running. | ||
| ||
Release the switch trigger and allow the screwdriver to |
| |
stop before changing its direction. |
| |
Note: Your screwdriver will not run unless forward/ |
| |
reverse lever is pushed fully to the left or right. |
|
FORWARD
Fig. 4
INSTALLING/REPLACING
BIT HOLDER AND BITS
See Figure 5.
■Unplug your screwdriver.
WARNING:
Failure to unplug your screwdriver could result in accidental starting causing serious injury.
TO INSTALL OR REPLACE BITS:
■Install 1/4 in. (6.4 mm) screwdriver bits by inserting them into magnetic bit holder.
Note: It is not necessary to remove adjustable nosepiece to install or remove bits. The magnetic bit holder shown in figure 5 illustrates the location of bit holder inside nosepiece.
■Replace 1/4 in. (6.4 mm) screwdriver bits by pulling them out of magnetic bit holder.
WARNING:
Your screwdriver should never be connected to a power supply when you are assembling parts, making adjustments, installing or removing bits, cleaning, or when not in use. Disconnecting your screwdriver will prevent accidental starting that could cause serious personal injury.
TO REMOVE MAGNETIC BIT HOLDER:
■Pull adjusting sleeve. The adjusting sleeve and adjustable nosepiece come off gear casing as a set.
■Remove magnetic bit holder. Pull bit holder out with pliers if you cannot remove it by hand.
TO REASSEMBLE BIT HOLDER AND NOSEPIECE:
■Push bit holder into hex opening of spindle until ball lock snaps in groove in bit holder shank.
■Attach adjustable nosepiece to the gear case. Align raised tab inside the adjustable nosepiece with the groove on the gear case and push the nosepiece as far as it will go.
PULL TO REMOVE | ADJUSTING |
ADJUSTABLE NOSEPIECE | SLEEVE |
1/4 in. (6.4 mm)
SCREWDRIVER
BIT
| GEAR CASING |
|
| MAGNETIC BIT HOLDER WITH |
|
ADJUSTABLE | 1/4 in. (6.4 mm) HEX OPENING |
|
|
| |
NOSEPIECE | ALIGN AND PUSH TO REPLACE |
|
| Fig. 5 | |
| ADJUSTABLE NOSEPIECE |
9
