OPERATION
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, this will cause the green LED to come on instead of the red LED. After 30 minutes, reinsert the battery pack in the charger. If the green LED continues to remain on, return battery pack to your nearest Ryobi Authorized Service Center for checking or replacing.
NOTE: This situation only occurs when continuous use of the tool causes the batteries to become hot. It does not occur under normal circumstances. Refer to CHARGING A COOL BATTERY PACK for normal recharging of batter- ies. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Ryobi Authorized Service Center for electrical check.
TO INSTALL BATTERY PACK
See Figure 4.
n Place the direction of rotation selector in center position.
�n Place the battery pack in the tool. Align raised rib on bat- tery pack with groove in the tool’s battery port.
�n Make sure the latches on each side of the battery pack snap in place and that battery pack is secured in the tool before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the tool and latches into place properly. Improper installa- tion of the battery pack can cause damage to internal components.
TO REMOVE BATTERY PACK
n Place the direction of rotation selector in center position.
�n Locate latches on side of battery pack and depress both sides to release battery pack.
�n Remove battery pack from the tool.
| P110 |
GREEN LED | CHARGER |
|
YELLOW LED
RED LED | Fig. 2 |
BATTERY PACK SHOWN IN CHARGER | |
| P110 |
| CHARGER |
P100 |
|
BATTERY PACK | Fig. 3 |
BATTERY PACK
LATCHES
DEPRESS LATCHES TO |
|
RELEASE BATTERY PACK | Fig. 4 |
12
