OPERATION
REMOVING BITS
See Figure 9.
n Lock the switch trigger by placing the direction of rotation selector in the center position.
nRotate the chuck sleeve clockwise to open the chuck jaws.
NOTE: Rotate the chuck body in the direction of the ar- row marked UNLOCK to loosen the chuck jaws. Do not use a wrench to tighten or loosen the chuck jaws.
nRemove the drill bit.
INSTALLING/REMOVING THE MAGNETIC BIT HOLDER
See Figure 11.
n Lock the switch trigger by placing the direction of rotation selector in the center position.
n Open or close the chuck jaws to a point where the opening |
WRONG
is slightly larger than the end of the magnetic bit holder. |
Also, raise the front of the drill slightly to keep the bit |
holder from falling out of the chuck jaws. |
n Insert the bit holder. |
BIT
Fig. 10
RELEASE (UNLOCK)
NOTE: Open the chuck jaws just enough to fully insert |
the end of the magnetic bit holder. The body of the bit |
holder should rest against the chuck jaws when the jaws |
are closed and tightened. |
n Tighten the chuck jaws on the bit holder. |
n Insert a bit into the open end of the magnetic bit |
holder. |
n To remove the magnetic bit holder, see Removing |
Bits. |
CHUCK
JAWS
MAGNETIC BIT HOLDER
GRIP (TIGHTEN)
CHUCK BODY
Fig. 11
15
