OPERATION
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, this will cause the green LED to come on instead of the red LED. After 30 minutes, reinsert the battery pack in the charger. If the green LED continues to remain on, return battery pack to your nearest Ryobi Authorized Service Center for checking or replacing.
NOTE: This situation only occurs when continuous use of the tool causes the batteries to become hot. It does not occur under normal circumstances. Refer to “CHARGING A COOL BATTERY PACK” for normal recharging of batter- ies. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Ryobi Authorized Service Center for electrical check.
INSTALLING THE BATTERY PACK
See Figure 5.
NOTE: The battery pack is shipped in a low charge condition. Therefore, it must be charged prior to use. Refer to page 12, “CHARGING BATTERY PACK” for charging instructions.
nPlace the battery pack in the saw. Align the raised rib on the battery pack with the groove inside the saw, then slide the battery pack into the saw.
nMake sure the latches on each side of your battery pack snap into place and the battery pack is secured in the saw before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the tool and latches into place properly. Improper installa- tion of the battery pack can cause damage to internal components.
REMOVING THE BATTERY PACK
See Figure 5.
nLocate the latches on the side of the battery pack and depress them to release the battery pack from the saw.
nRemove battery pack from your saw.
YELLOW |
| RED | |
GREEN | LED | ||
LED | |||
| |||
| LED |
|
BATTERY PACK SHOWN
IN CHARGERP110 CHARGER
Fig. 4
DEPRESS LATCHES TO REMOVE BATTERY PACK
TO
INSTALL
BATTERY
PACK
Fig. 5
13
