ADJUSTMENTS

INSERTING THE STARTING PIN

Place the starting pin on the router table and use it as a pivot point when cutting small, odd-shaped pieces.

NOTE: It is not necessary to use the fence when you are using the starting pin. Additionally, only use piloted cutters when using the starting pin.

See Figure 15.

Follow these directions to insert the starting pin.

QPlace the starting pin into the threaded hole to the right of the router table throat opening.

QTurn the pin clockwise to secure.

ADJUSTING THE MITER GAUGE

Follow these directions to adjust the miter gauge.

QLoosen the miter gauge knob.

QRotate the miter gauge to the desired angle.

QTighten the miter gauge knob.

OPERATION

WARNING:

Always wear safety goggles or safety glasses with side shields when operating this tool. Failure to do so could result in dust, shavings, or loose particles being thrown into your eyes, resulting in serious injury.

USING THE ROUTER WITH THE ROUTER TABLE

Observe the following rules when using the router with the router table.

QRead the entire Operator’s Manual.

QAlways plug the router into the router table switched outlet. Never plug a router table mounted router into

another power source.

QLock-on the router switch. Refer to the Operator’s Manual for details.

QMake sure the router table switch is off. Remove the switch key.

QPlug the router table power cord into a power source.

QAlways control the power to the router with the router table switch whenever the router is mounted on the table.

Fig. 15

SWITCHED

OUTLET

Fig. 16

15

Page 15
Image 15
Ryobi RT101 manual Operation, Inserting the Starting PIN, Adjusting the Miter Gauge, Using the Router with the Router Table