Ryobi RT101 manual To Attach the Fence

ASSEMBLY

TO ATTACH THE FENCE

See Figure 5.

Follow these directions to attach the fence.

Q Place the router table right side up with the back edge closest to you.

Q Position the fence on the table with the four black knobs facing you.

QAlign the two holes on the bottom of the fence with the two channels on the router table.

Q Secure the fence to the table with the two fence lock knobs and carriage bolts.

TO ATTACH THE CUTTER GUARD ASSEMBLY/

VACUUM ATTACHMENT

See Figure 6.

Follow these directions to attach the cutter guard assembly/vacuum attachment.

QPlace the router table right side up with the back edge closest to you.

QScrew the guard post securely into one of the

threaded holes on the top of the fence.

NOTE: When the fence is close to the cutter, place the guard post in the off-center threaded hole to provide protection from the cutter and allow for proper suction for the vacuum.

Q Loosen the clear plastic ring by turning the black knob counterclockwise.

Q Slide the ring over the guard post.

Q Center the cutter guard over the throat of the router table.

Q Tighten the cutter guard by turning the black knob clockwise.

NOTE: While routing, you can insert a standard shop vacuum into the top of the clear plastic ring to keep dust down to a minimum.

TO ATTACH THE MITER GAUGE

See Figure 7.

Follow these directions to attach the miter gauge.

QPlace the router table right side up with the front edge closest to you.

QPlace the miter gauge bar in the track near the front

of the table with the pointer on the right.

Q Position the miter gauge onto the miter gauge bar placing the miter gauge under the pointer and align- ing the hole in the miter gauge over the small post in the miter gauge bar.

QScrew the miter gauge knob into the threaded hole in the miter gauge bar.

Fig. 5

Fig. 6

Fig. 7

10