Ryobi RY14110 manuel dutilisation Troubleshooting, Problem Possible Cause Solution

TROUBLESHOOTING

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.

PROBLEM	POSSIBLE CAUSE	SOLUTION
Handle not in position	Carriage bolts not seated properly.	Adjust the height of the handle and
		make sure the carriage bolts are seated
		properly.
	Handle knobs not tightened.	Tighten handle knobs.
Mower not starting	Battery is low in charge.	Charge the battery.
	Battery is either inoperable or will not	Replace the battery.
	take a charge.
Mower cutting grass unevenly	Lawn is rough or uneven or cutting	Move the wheels to a higher position.
	height not set properly.	All wheels must be placed in the same
		cutting height for the mower to cut
		evenly.
Mower not mulching properly	Wet grass clippings sticking to the un-	Wait until the grass dries before mow-
	derside of the deck.	ing.
Mower hard to push	High grass, rear of mower housing and	Raise cutting height.
	blade dragging in heavy grass, or cut-
	ting height too low.
Mower not bagging properly	Cutting height set too low	Raise cutting height.
Mower vibrating at higher speed	Blade is unbalanced, excessively or	Replace the blade.
	unevenly worn.
	Bent motor shaft.	Stop the motor, remove fuse key and
		battery, disconnect the power source,
		and inspect for damage. Have repaired
		by an authorized service center before
		restarting.
Mower doesn’t self-propel		Take the mower to an authorized service
		center.
Motor stops while cutting	Cutting height set too low	Raise the cutting height

MAKE THE MOST OF YOUR PURCHASE!

Go to http://register.ryobitools.com and register your new tool on-line.

Your product has been fully tested prior to shipment

to ensure your complete satisfaction.

For any questions about operating or maintaining

your product, call the Ryobi Help Line!

13 — English