ASSEMBLY
UNPACKING
This product requires assembly.
nCarefully remove the product and any accessories from the box. Make sure that all items listed in the packing list are included.
nInspect the product carefully to make sure no breakage or damage occurred during shipping.
nDo not discard the packing material until you have care- fully inspected and satisfactorily operated the product.
nIf any parts are damaged or missing, please call
packing list
Powerhead
Front Handle
Bottle of
Operator’s Manual
WARNING:
If any parts are damaged or missing do not operate this product until the parts are replaced. Operation of this product with damaged or missing parts or without an attachment could result in serious personal injury.
WARNING:
Do not attempt to modify this product or create acces- sories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
Push in the button located on the attachment shaft. Align the button with the guide recess on the powerhead coupler and slide the two shafts together. Rotate the attachment shaft until the button locks into the positioning hole.
NOTE: If the button does not release completely in the positioning hole, the shafts are not locked into place. Slightly rotate from side to side until the button is locked into place.
Tighten the knob securely.
WARNING:
Be certain the knob is fully tightened before operating equipment; check it periodically for tightness during use to avoid serious personal injury.
removing an attachment from the powerhead
For removing or changing the attachment:
Loosen the knob.
Push in the button and twist the shafts to unlock and separate.
ATTACHING THE STORAGE HANGER
See Figure 3.
There are two ways to hang your attachment for storage.
To use the hanger cap, push in the button and place the hanger cap over end of the lower end attachment shaft. Slightly rotate the cap from side to side until the button locks into place.
The secondary hole in the attachment shaft can be used for hanging purposes as well.
WARNING:
To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts.
installING an attachment to the powerhead
See Figure 2.
WARNING:
ATTACHING THE FRONT handle
See Figure 4.
Remove wing nut, washer, and bolt from the front handle.
Install the front handle onto the top side of the drive shaft housing in the area indicated by the label.
NOTE: The open side of the handle should face the operator.
Place the bolt through the front handle.
NOTE: The hex bolt head fits inside the hex recess molded into one side of the handle.
Never install, remove, or adjust any attachment while powerhead is running. Failure to stop the engine can cause serious personal injury. Never operate powerhead without an attachment.
The attachment connects to the powerhead by means of a coupler device.
Loosen the knob on the coupler of the powerhead shaft and remove the hanger cap from the attachment.
Reinstall the washer and wing nut.
Tighten wing nut securely.
7 — English
