Ryobi RY34001 Troubleshooting, Problem, Possible Cause, Solution, See Adding/Checking Engine

Models: RY34001

1 46
Download 46 pages 52.26 Kb
Page 14
Image 14
TROUBLESHOOTING

TROUBLESHOOTING

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.

PROBLEM

POSSIBLE CAUSE

SOLUTION

Engine will not start

No spark.

Clean or replace spark plug. Reset

 

 

spark plug gap. Refer to Spark Plug

 

 

Replacement earlier in this manual.

 

No fuel.

Push primer bulb until bulb is full of

 

 

fuel. If bulb does not fill, primary fuel

 

 

delivery system is blocked. Contact an

 

 

authorized service center. If primer bulb

 

 

fills, engine may be flooded, proceed

 

Engine is flooded.

to next item.

 

 

 

 

Set the start lever to the START position.

 

 

Squeeze the trigger and pull the rope

 

 

repeatedly until the engine starts and

 

 

runs.

 

 

NOTE: Depending on the severity of

 

 

the flooding, this may require numerous

 

 

pulls of the rope.

 

 

 

Engine does not reach full speed and

Air filter screen is dirty.

Clean air filter screen. Refer to Clean-

emits excessive smoke

 

ing Air Filter Screen earlier in this

 

 

manual.

 

Spark arrestor screen is dirty.

Contact an authorized service center.

 

Spark plug fouled.

Clean or replace spark plug. Reset

 

 

spark plug gap. Refer to Spark Plug

 

 

Replacement earlier in this manual.

 

 

 

Engine starts, runs, and accelerates

Idle speed screw on carburetor needs

Turn idle speed screw clockwise to

but will not idle

adjustment.

increase idle speed. See Figure 9.

 

 

 

Engine emits too much smoke

Too much oil in crankcase.

Drain lubricant and refill with correct

 

 

amount of 10W-30 engine lubricant.

 

 

See Adding/Checking Engine

 

 

Lubricant in the Operation section of

 

 

this manual.

 

 

 

Engine rope cannot be pulled

Oil has entered the combustion

This is usually caused by storing the unit

 

chamber.

for an extended time with the engine in

 

 

an upside-down position. Remove and

 

 

clean the spark plug. Drain the oil out

 

 

of the spark plug hole, then reinstall the

 

 

spark plug.

 

 

Check engine lubricant and add if

 

 

necessary prior to starting. Refer to

 

 

Changing Engine Lubricant earlier in

 

 

this manual.

 

 

 

12 — English

Page 14
Image 14
Ryobi RY34001 manuel dutilisation Troubleshooting, Problem, Possible Cause, Solution, ing Air Filter Screen earlier in this