OPERATION
PROPER CUTTING STANCE
See Figure 12.
n Weight should be balanced with both feet on solid ground.
nKeep left arm with elbow locked in a "straight arm" posi- tion to withstand any kickback force.
nYour body should always be to the left of the chain line.
nThumb should be on underside of handlebar.
BASIC CUTTING PROCEDURE
Practice cutting a few small logs using the following tech- nique to get the "feel" of using the saw before you begin a major sawing operation.
nTake the proper stance in front of the wood with the saw off.
nPress the switch lock and squeeze the switch trigger then release switch lock and let the chain accelerate to full speed before entering the cut.
nBegin cutting with the saw against the log.
nKeep the unit running the entire time you are cutting, maintain a steady speed.
nAllow the chain to cut for you; exert only light downward pressure. If you force the cut, damage to the bar, chain, or unit can result.
nRelease the switch trigger as soon as the cut is completed, allowing the chain to stop. If you run the saw without a cutting load, unnecessary wear can occur to the chain, bar, and unit.
nDo not put pressure on the saw at the end of the cut.
WORK AREA PRECAUTIONS
nCut only wood or materials made from wood, no sheet metal, no plastics, no masonry, no
nNever allow children to operate the saw. Allow no person to use this chain saw who has not read this Operator's Manual or received adequate instructions for the safe and proper use of this chain saw.
nWhen felling a tree, keep everyone - helpers, bystanders, children, and animals - a safe distance from the cutting area. During felling operations, the safe distance should be a least twice the height of the largest trees in the fell- ing area. During bucking operations, keep a minimum distance of 15 feet between workers. Trees should not be felled in a manner that would endanger any person, strike any utility line or cause any property damage. If the tree does make contact with any utility line, the utility company should be notified immediately.
CHAIN LINE
STRAIGHT ARM POSITION
Fig. 12
nAlways cut with both feet on solid ground to prevent be- ing pulled off balance.
nDo not cut above chest height, as a saw held higher is difficult to control against kickback forces.
nDo not fell trees near electrical wires or buildings. Leave this operation for professionals.
nCut only when visibility and light are adequate for you to see clearly.
TREE FELLING
Unusual Hazardous Tree Felling Conditions
Do not fell trees during periods of high wind or heavy pre- cipitation.
WARNING:
Do not cut down trees having an extreme lean or large trees that have rotten limbs, loose bark, or hollow trunks. Have these trees pushed or dragged down with heavy equipment, then cut them up.
WARNING:
Do not cut trees near electrical wires or buildings.
WARNING:
Check the tree for damaged or dead branches that could fall and hit you during felling.
16
