FEATURES
SAW TABLE
Your scroll saw has an aluminum saw table that provides a working surface to support your workpiece.
TABLE LOCK LEVER
Allows you to tilt the table and lock it at the desired angle up to 45 degrees.
BEVEL SCALE
The bevel scale and indicator are located on the front of the saw for easy viewing. They show the angle of the table.
ASSEMBLY
Your 16 in. scroll saw was fully assembled at the factory. Before operating this tool, it is important to check all align- ments and settings. Normal handling during shipment may have changed settings.
WARNING:
To avoid serious personal injury from unexpected tool movement, always securely mount scroll saw to a workbench.
MOUNTING SCROLL SAW TO WORKBENCH
See Figure 5.
If the scroll saw is to be used in a permanent application, we recommend that you secure it in a permanent location such as a workbench. When mounting the saw to a workbench, holes should be drilled through the supporting surface of the workbench using dimensions illustrated.
■Each hole in the base of the saw should be bolted securely using 5/16 in. diameter machine bolts, lock washers, and hex nuts (not included). Bolts should be of sufficient length to accommodate the saw base, lock washers, hex nuts, and the thickness of the workbench.
■Locate and mark the holes where scroll saw is to be mounted.
■Drill (3) 3/8 in. diameter holes through workbench.
■Place scroll saw on workbench aligning holes in the base with holes drilled in the workbench.
■Insert all three 5/16 in. bolts and tighten securely with lock washers and hex nuts.
Note: All bolts should be inserted from the top. Install the lock washers and hex nuts from the underside of the bench.
Supporting surface where scroll saw is mounted should be examined carefully after mounting to insure that no move- ment during use can result. If any tipping or walking is noted, secure workbench or supporting surface before beginning cutting operations.
12 in.
3/8 in. |
dia. hole |
5 in. |
|
|
| 17 in. |
|
|
| 2 in. |
|
|
|
|
|
|
24 in.
Fig. 5
Page 10
