OPERATION
LOCK OFF POST
See Figure 19.
To prevent unauthorized use of your scroll saw, we suggest that you disconnect it from the power supply and lock the knob in the OFF position. A padlock with a 3/16 in. shackle should be used. When the lock is installed and locked, as illustrated, the switch is inoperable. Store the padlock key in another location.
■To lock saw in the OFF position, install a padlock through the lock off post beside the knob as illustrated and lock the padlock. (Padlock is not supplied with the saw.)
WARNING:
For your own safety, always push the knob OFF when machine is not in use. Also, in the event of a power failure, push knob OFF. Lock the scroll saw switch OFF with a padlock. This will prevent the machine from starting up again when the power comes back on. Failure to heed this warning can result in serious personal injury.
INTERIOR SCROLL CUTTING
See Figure 20.
■One of the features of a scroll saw is that it can be used to make scroll cuts on the interior of a board without breaking or cutting through the edge or perimeter of the board.
WARNING:
To avoid possible serious injury from accidental starting, always turn the switch OFF and remove plug from power source outlet before removing or replacing the blade.
■To make interior cuts in a board, remove the scroll saw blade as explained in the Installing Blades section on pages 12 – 14.
■Drill a 1/4 in. hole in the board to be used to make interior cuts.
■Place the board on the saw table with the hole in the board over the access hole in the table.
■Install blade through hole in board then adjust the hold down foot and the blade tension. See pages 16 and 17.
■When finished making the interior scroll cuts, simply remove the blade from the blade holders as described in the Installing Blades section, and remove the board from the table.
0˚
PADLOCK 
ON/OFF KNOB | Fig. 19 |
INTERIOR
CUT
DRILL HOLE | 45˚ |
|
| 30˚ | 15˚ |
| WORKPIECE | Fig. 20 |
Page 16
