FEATURES
MOUNTING HOLE
See Figure 6.
Your miter saw should be mounted to a firm supporting surface such as workbench. Four bolt holes have been provided in the saw base for this purpose. Each of the four mounting holes should be bolted securely using 3/8 in. (10
mm)machine bolts, lock washers, and hex nuts (not included). Bolts should be of sufficient length to accommodate the saw base, lock washers, hex nuts, and the thickness of the workbench.
Tighten all four bolts securely.
The hole pattern, shown in figure 6, is for an 18 in. (457 mm) x 24 in. (610 mm) workbench. Carefully check the workbench after mounting to make sure that no movement can occur during use. If any tipping, sliding, or walking is noted, secure the workbench to the floor before operating.
OPTIONAL ACCESSORIES
Optional accessories, provided on some models, are avail- able for use with your saw. They include table extensions, a stop block, work clamp, and dust bag.
Table extensions increase the work surface to 36 in. (914 mm) wide, providing support for cutting long workpieces.
The stop block provides a stop for making repetitive cuts to same length. It can be installed on either side of saw base.
The work clamp provides a means for clamping workpiece securely against the fence when making a cut. Standard "C" clamps can also be used for this purpose.
The dust bag catches sawdust, helping keep work area cleaner.
If these accessories were not provided with our saw, they are available from your Ryobi dealer. For the location of a distributor near you, call
ELECTRICAL CONNECTION
Your saw has a precision built electric motor. It should be connected to a power supply that is 120 volts, 60 Hz, AC only (normal household current). Do not operate this tool on direct current (DC). A substantial voltage drop will cause a loss of power and the motor will overheat. If your tool does not operate when plugged into an outlet,
WARNING:
The operation of any saw can result in foreign objects being thrown into your eyes, which can result in severe eye damage. Before starting power tool operation, always wear safety goggles or safety glasses with side shields and a full face shield when needed. We recommend wide vision safety mask for use over eyeglasses or standard safety glasses with side shields.
WARNING:
Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alter- ation or modification is misuse and could result in a hazardous condition leading to possible serious per- sonal injury.
TRACE HOLES
AT THESE LOCATIONS FOR HOLE PATTERN
|
|
| TRACE HOLES |
|
|
| AT THESE LOCATIONS |
|
|
| FOR HOLE PATTERN |
5 |
|
| 5 |
4 |
| 4 |
|
31.6 |
| 31 |
|
| 30 | .6 |
|
|
|
| |
|
| .5 |
|
| 15 | 22 |
|
| 15 |
|
SAW BASE | MOUNTING SURFACE |
Fig. 6
Page 11
