Ryobi TS1301 warranty Cutting Warped Material, Clamping Wide Workpieces, See Figures 27, Right

OPERATION

CUTTING WARPED MATERIAL

See Figures 27 and 28.

When cutting warped material, always make sure it is positioned on the miter table with the convex side against the fence as shown in figure 27.

If the warped material is positioned the wrong way as shown in figure 28, it will pinch the blade near the completion of the cut.

WARNING:

To avoid a kickback and to avoid serious personal injury, never position the concave edge of bowed or warped material against the fence.

CLAMPING WIDE WORKPIECES

See Figure 29.

When cutting wide workpieces that are too wide to be clamped with a work clamp, a C-clamp must be used. For example, when cutting 2 in. x 6 in. boards, they should be clamped with a C-clamp as shown in figure 29.

Page 20

5			5
4		4
31.6		31
	30	.6
	15	22.5
		15

RIGHT Fig. 27

5			5
4		4
3		.6
1.6	30	31
	15	22.5
		15

WRONG Fig. 28

WIDE

BOARD

8 7 6 5 4 3

2 1

C-CLAMP

Fig. 29