Ryobi TS1552DXL manual Rear Bracket, Table Extensions, Assembly, See Figures 13

ASSEMBLY

REAR BRACKET

See Figure 12.

WARNING:

A rear bracket is included with this miter saw to prevent tipping if the saw arm is released suddenly. Do not use this saw before installing the rear bracket and securely mounting the saw to a work surface.

n Standing behind the mounted miter saw, slide the rear bracket in the holes at the base of the saw.

n Secure in place using hex nuts.		HEX
n Tighten securely.
		NUT
TABLE EXTENSIONS	BASE	REAR
See Figures 13 - 14.		BRACKET
		Fig. 12
To use the stop block, slide the stop block on the back arm
of the desired table extension first.
To install table extensions, insert the ends of extensions
into the holes in the sides of the base. See Figures 13 - 14.
Adjust the extensions to the desired length.
Secure extensions in place by positioning a clamp bracket
under each table extension beneath the miter table. Orient		TABLE
each clamp bracket as shown in figure 14.
		EXTENSION
Secure each clamp bracket in place with a clamp bracket
screw. The clamp bracket screw threads through the clamp
bracket and tightens against bracket support on bottom of
miter table, securing clamp bracket against table extension.		MITER
		SAW BASE

Fig. 13

SAW VIEWED FROM BOTTOM

BRACKET

MITERSUPPORT

SAW

BASE

TABLE	CLAMP
	BRACKET
EXTENSION	ASSEMBLED

CLAMP

BRACKET

CLAMP

BRACKET SCREW

Fig. 14

16