Ryobi TS1552DXL Changing the Batteries, See Figures 46, Do not attempt to activate the laser

MAINTENANCE

CHANGING THE BATTERIES

See Figures 46 - 47.

nUnplug the saw.

nRemove the laser guide from the saw and lay it on a flat surface with the two phillips screws facing upward.

nRemove the screws and separate the laser guide cover from the laser guide support.

nRemove the three button cell batteries using a non-con- ductive device such as a toothpick.

NOTE: Replace the batteries with silver oxide batteries that have a rating of 1.5 volt and 180 mah (milliampere hour) minimum (Number 357 silver oxide only).

When replacing the batteries, the laser guide should be thor- oughly cleaned. Use a soft paintbrush or similar device, to remove all sawdust and debris.

Do not attempt to activate the laser.

The laser is activated by means of a centrifugal switch only while the saw motor is running and the laser guide is mounted on the saw.

nAfter cleaning the laser guide and replacing the batteries, secure the laser guide cover to laser guide support using the two phillips head screws. For proper assembly, be sure to align the key on the laser guide cover with the key slot in the laser guide support. Tighten screws securely.

NOTE: Aperture in laser guide cover must be aligned with aperture in laser guide support.

LASER GUIDE

SUPPORT

LASER GUIDE

SUPPORT

(UPSIDE DOWN VIEW)

	E	CE
	IN
	L	L
	A	L
L	K
A

SCREWS

APERTURE

KEY

PLASTIC

BATTERY

INSULATOR

								BATTERIES
		N
	LI E		C
	A
	K		L
L			E
A			L
					A	LI	N
			L	K			E	NEGATIVE (–)
							C
							L
			A				E
							L

CAUTION:

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

LASER GUIDE	KEY
COVER
	SLOT

APERTURE

Fig. 46

LASER GUIDE

DANGER: Laser radiation when open and inter-	Fig. 47
lock defeated. AVOID DIRECT EYE EXPOSURE.

32