Ryobi Outdoor CS30, SS30, BC30 Assembly, See Figure, Front Handle, Wing Nut Bolt, Flat Washer

ASSEMBLY

ATTACHING THE FRONT HANDLE - CS30 AND SS30

See Figure 4.

1.Remove the front handle, bolt, flat washer, lock washer, and wing nut from the Owner’s Kit.

2.Install the front handle onto the top side of the drive shaft housing and move it to a comfortable position.

3.Place the bolt through the front handle

NOTE: The hex bolt head fits inside the hex recess molded into one side of the handle.

4.Install the flat washer, lock washer, and wing nut.

5.Tighten wing nut securely.

ATTACHING THE “J” BARRIER HANDLE - BC30

See Figure 5.

A barrier handle must be used for ensuring the best control and maximizing operator safety when using a brushcutter.

1.Hold the top and bottom clamp snugly in position on the shaft housing so that handle will be located to the operator's left.

2.Insert the end of the handle between the clamps.

3.Align the bolt holes and push the long bolt (1/4-20 x 1-1/2 in.) through the handle side.

4.Place short bolt (1/4-20 x 1 in.) through opposite side of clamp. Install flat washer, lock washers and hex nuts to hold the assembly in place.

5.After assembly is complete, adjust the position of the handle for best balance and comfort.

6.Tighten first the long bolt and then the short bolt.

FRONT HANDLE	LOCK
	WASHER

WING

NUT

BOLT

FLAT WASHER Fig. 4

	BOLT
FRONT	1/4-20 x 1 in.	BOLT
		1/4-20 x 1 1/2 in.
HANDLE

STRAP

HANGER

CLAMP

CLAMP	FLAT WASHER
	LOCK WASHER
HEX NUT	Fig. 5

Page 11