Maintenance, Fuel Cap, Spark Plug | Ryobi Outdoor CS30 ZR30000

MAINTENANCE

FUEL CAP

WARNING:

A leaking fuel cap is a fire hazard and must be replaced immediately.

The fuel cap contains a non-serviceable filter and a check valve. A clogged fuel filter will cause poor engine perfor- mance. If performance improves when the fuel cap is loosened, check valve may be faulty or filter clogged. Replace fuel cap if required.

SPARK PLUG

This engine uses a Champion RCJ-6Y with 0,63 mm (.025 in.) electrode gap. Use an exact replacement and replace annually.

STORAGE (1 MONTH OR LONGER)

1.Drain all fuel from tank into a container approved for gasoline. Run engine until it stops.

2.Clean all foreign material from the trimmer. Store it in a well-ventilated place that is inaccessible to children. Keep away from corrosive agents such as garden chemicals and de-icing salts.

3.Abide by all ISO and local regulations for the safe storage and handling of gasoline. Excess fuel should be used up in other 2-cycle engine powered equipment.

Page 22

Image 22

Ryobi Outdoor CS30 ZR30000, SS30 ZR30002, BC30 ZR30004 manual Maintenance, Fuel Cap, Spark Plug, STORAGE 1 MONTH OR LONGER

Contents

ZR30000 Series OPERATORS MANUAL30cc String Trimmers and Brushcutter SAVE THIS MANUAL FOR FUTURE REFERENCE TABLE OF CONTENTS INTRODUCTION GENERAL SAFETY RULES READ ALL INSTRUCTIONS SPECIFIC SAFETY RULES SPECIFIC SAFETY RULES FOR TRIMMER USE NAME SYMBOLSSYMBOL EXPLANATION SYMBOL SIGNAL SAVE THESE INSTRUCTIONSSERVICE MEANING Weight - without fuel SPECIFICATIONSUNPACKING String cutting width REAR HANDLE FEATURESHOUSING FRONT HANDLE KNOB CURVED SHAFT GRASS CHOKE LEVER COUPLER THROTTLE TRIGGER DRIVE SHAFT COUPLER COUPLER THROTTLE TRIGGER DRIVE SHAFT HOUSINGSTARTER GRIP THROTTLE TRIGGER STRING TRIMMER SHAFT COUPLER GUIDE RECESS BUTTON ASSEMBLYSee Figure POSITIONING HOLE KNOB BOLT 1/4-20x 1 in. BOLT FRONT1/4-20 x 1 1/2 in FRONT HANDLE LOCK WASHER WING NUT BOLTFLAT WASHER HANDLE STRAP HANGER CLAMP BOLT BRACKET TO ATTACH THE CURVED SHAFT GRASS DEFLECTORZR30000 See Figure SLOT GEAR HEAD REMOVING THE TRI-ARCBLADE AND BRUSHCUTTER GUARD GEAR HEAD FLANGED WASHER STRING HEAD ASSEMBLYLATCH STRAP HANGER SHOULDER See Figures 10 and SLOT LOOSEN TIGHTEN INSTALLING THE TRI-ARCBLADE AND BRUSHCUTTER GUARDGEAR HEAD FLANGED WASHER SLOT CUPPED WASHER FUEL MIXTURE HIGH QUALITY 2-CYCLEENGINE OIL OPERATIONFUEL MIXTURE GASOLINE CUTTING TIPS TO ADVANCE THE CUTTING LINETO ADVANCE THE CUTTING LINE MANUALLY See Figures 16 and TRI-ARCBLADE See Figures 19 andBLADE THRUST CUTTING TECHNIQUE - BLADE See Figures 21, 22, and IGNITION SWITCH THROTTLE TRIGGERPRIMER BULB STARTER GRIP IGNITION SWITCH STARTING TO STOP THE ENGINE NEW PREWOUND SPOOL MAINTENANCETo install the spool retainer See Figures 24 and FIRST STRING See Figures 26, 27, andARROWS ON SPOOL ANCHOR HOLE FIRST STRING SLOT SECOND STRING LATCH PULL COVER TO OPEN Cleaning InstructionsSee Figures 29 and FILTER SLOTS ON AIR FILTER BASE TABS ON AIR SPARK PLUG FUEL CAPSTORAGE 1 MONTH OR LONGER TROUBLESHOOTING IDLE SPEED SCREW OWNERSWARRANTY RESPONSIBILITIES WARRANTYMANUFACTURERS WARRANTY COVERAGE MAINTENANCE REQUIREMENTS 5 Hours Emissions PartsEach Use AIR FILTER ASSY NOTES • HOW TO ORDER REPAIR PARTS RYOBI TECHNOLOGIES INC• SERVICE • MODEL NO. AND SERIAL NO

Ryobi Outdoor CS30 ZR30000 manual Maintenance, Fuel Cap, Spark Plug, STORAGE 1 MONTH OR LONGER

Models: BC30 ZR30004 CS30 ZR30000 SS30 ZR30002

FUEL CAP

SPARK PLUG

STORAGE (1 MONTH OR LONGER)