Green
Yellow
1 
2
3
ENGLISH 41
When the water tank is empty, remove the water tank, rinse it and fill it up to the MAX level with fresh water. Place it back into the machine.
Empty the container and place it back under the steam/hot water wand and dispensing spout.
When the amount of water needed for the rinse cycle has been completely dispensed, this icon on the side is displayed. Press the“ 
” button to quit the descaling cycle.
Press the “
” button to prime the circuit.
The machine now carries out the
Remove and empty the container.
Empty the drip tray and place it back.
The descaling cycle is now complete.
Remove the small white water filter and place back the “INTENZA+” water filter into the water tank if it was installed and the Classic Milk Frother.
Note:
At the end of the descaling cycle, wash the brew group as described in the “Weekly cleaning of the brew group” chapter.
The two rinse cycles are performed in order to have the circuit cleaned with a preset amount of water to ensure proper machine performance. If the water tank is not filled up to MAX level, the machine might require three or more cycles.
