Saeco Coffee Makers HD8761, HD8764 English, Troubleshooting, Machine actions, Causes, Solutions

Models: HD8761 HD8764

1 56
Download 56 pages 12.41 Kb
Page 47
Image 47
TROUBLESHOOTING

ENGLISH 45

TROUBLESHOOTING

This chapter summarizes the most common problems you could en- counter with your machine. If you are unable to solve the problem with the information below, visit www.philips.com/support for a list of frequently asked questions or contact the Philips Saeco hotline in your country. You find its contact details in the warranty booklet by-packed separately or on www.philips.com/support.

Machine actions

Causes

Solutions

The machine does not switch

The machine is not connected to

Connect the machine to the electric

on.

the electric network, or the main

network, turn the main switch to “I”

 

switch is in “O” position.

position

The drip tray gets filled al-

Sometimes water is drained auto-

This is seen as normal machine

though no water is drained.

matically by the machine into the

behavior.

 

drip tray to manage the rinsing of

 

 

the circuits and ensure optimum

 

 

machine performance.

 

The red Machine actions icon is always displayed on the machine.

The coffee grounds drawer was emptied with the machine off.

The coffee grounds drawer must always be emptied with the machine

on. Wait until the Causes icon is display- ed before refitting the drawer.

Coffee is not hot enough.

The cups are cold.

Preheat the cups with hot water.

No hot water or steam is

The hole of the hot water / steam

Clean the hole of the steam wand

dispensed.

wand is clogged.

using a pin.

 

 

Make sure that the machine is off

 

 

and cold before performing this

 

 

operation.

 

Classic Milk Frother is dirty.

Clean the Classic Milk Frother.

Coffee does not have enough

The blend is unsuitable, coffee is

Change coffee blend or adjust the

crema.

not freshly roasted or the grind is

grinder as explained in chapter

(See note)

too coarse.

“Adjusting the ceramic coffee

 

 

grinder”.

The machine takes a long time to warm up or the amount of water dispensed is too little.

The machine circuit is clogged by Descale the machine. limescale.

The brew group cannot be removed.

The brew group is out of place.

Turn the machine on. Close the ser-

 

vice door. The brew group automati-

 

cally returns to the initial position.

The coffee grounds drawer is

Remove the coffee grounds drawer

inserted.

before removing the brew group.

Page 47
Image 47
Saeco Coffee Makers HD8761 English, Troubleshooting, Machine actions, Causes, Solutions, and cold before performing this