Saeco Coffee Makers HD8833 manual Coffee Brewing, Stand-by

The machine allows slight adjustments to the coff ee grinder to adapt it to the kind of coffee used.

To make any adjustment, press and turn the knob inside the coffee bean hopper.

Press and turn the knob by one notch at

atime and brew 2-3 cups of coffee; this is the only way to notice differences in grind.

The reference marks inside the coffee bean hopper indicate the grind setting. There are 5 different grind settings to cho- ose from with the following references:

Large Mark - Coarse Grind

Small Mark - Fine Grind.

Adjusting the Coffee Length

The machine allows you to adjust the amount of brewed coffee according to your taste and/or the size of your cups.

Each time the “” or “” buttons are

pressed and released, the machine brews

a pre-set amount of coffee, as per factory

settings. This amount may be reprogram-

med to your taste. Each button may be

individually programmed for a specific brew setting.

As an example, the following procedure describes the programming of the but- ton“”, which is normally associated with espresso coffee.

• Place a cup under the dispensing spout.

•Hold the “” button pressed for 5 seconds to enter the programming

	mode; the button “	” blinks together
	with the lights of the display shown in
Blinking	the fi gure and the coffee will start to
	be brewed. These light signals remain
	active during the whole cycle.

•Press the“”button again when the amount of coffee in the cup reaches the desired level.

At this point the button“”is program- med; each time it is pressed and released, the machine will brew the same amount of coffee that was just programmed.

Stand-by

The machine is designed for energy sa- ving. The machine automatically turns off after 30 minutes of inactivity.

The“ “ button blinks when the machine is in stand-by mode.

Note: During the turning off phase, the machine performs a rinse cycle, if a coffee product has

been brewed.

Warning: When turning the machine on after it has been turned com- pletely off, the machine will be in stand-by mode

To turn the machine on again simply press the STAND-BY button (if the power but- ton is set to “I”). In this case the machine will go through the rinse cycle only if the boiler is cold.

COFFEE BREWING

Note: Should the machine not brew coffee, make sure that

the water tank contains water.

	Before brewing coffee, check
	the lights on the display and
	on the control panel. Check that
	the water tank and the coffee bean
Steady on	hopper are full.
	Leave the selector on the
Steady on	coffee position “ ” during the
	dispensing phase.
	Before brewing the coffee,
	adjust the height of the di-
	spensing spout according to your
	needs, and select the aroma or the
	pre-ground coffee.

• 11 •