Optional Accessories
37
directions provided in par.8; hot water will flow out of the lower part of the cappuccinatore.
While hot water is being dispensed, the silicone tube (41) inside the cappuccinatore must be inserted into the grating of the drip tray. Make sure the silicone tube cannot slip out while the machine is in use.
13.3.2Steam/Cappuccino with the cappuccinatore
The steam may be used to froth milk for cappuccino and to heat up beverages.
Danger of scalding!
The steam may be preceded by brief sprays of hot water. The dispensing tube can reach very high temperatures: avoiding touching it directly with your hands.
41 |
•When you turn on the machine, the tem- perature control light (18) will flash until the machine heats up to the right tem- perature.
•Before dispensing steam, make sure the green temperature ready light (18) remains lit and that the water container is full.
•When the green temperature ready light
(18)remains lit, the machine is ready to dispense steam.
•Position the cappuccinatore over the drip tray, open the “hot water/steam” knob
(11)for a few seconds to discharge residual water from the cappuccinatore; in a short time only steam will issue from the tube.
•Close the knob (11).
•Place the intake tube (41) in a suitable receptacle or directly into a container of milk, placed next to the machine.
•Place a cup containing previously prepared coffee beneath the nozzle of the cappuccinatore;
•Open the knob (11); frothed milk will start issuing from the cappuccinatore.
•Move the pin on the cappuccinatore to regulate the thickness of the foam; by pushing it upward you will increase its volume.
iWhen preparing cappuccino, use cold milk to ensure the best
results.
•When you have finished using the cappuccinatore and steam, clean the cappuccinatore to remove residual milk.
•Place a container filled with fresh drinking water alongside the machine and place the tip of the intake tube (41) inside the container.
•Proceed as if you were making cappuc- cino, allowing the dirty water to flow into a receptacle or directly into the drip tray.
13.3.3 Cleaning the cappuccinatore.
After using the cappuccinatore, you should
