To Assemble (continued)
2 Footrest Frame: | 2 |
| 2a |
Footrest Frame |
Position so curved loops points downward (Figure 2).
Curved
Slide Footrest Frame on right side and then left side
Loops (Figure 2a).
3 Vibration Unit:
Locate the Vibration Unit and Vibration Unit Mounting Screw.
Slide Vibration Unit onto Headrest Frame and align with screw hole.
Insert Mounting Screw through Vibration Unit and into Headrest Frame (approximately 1/4 of the screw should be showing). Secure together using a Phillips head screwdriver
(Figure 3).
NOTE: When tightening screw, make sure it engages to Headrest Frame. If needed, slightly reposition Vibration Unit until screw is properly located and repeat assembly.
3
Screw Hole
Vibration Unit
4 Headrest Frame:
Insert tab on Right Leg into slot on Right Connector of Headrest Frame. Be sure end of headrest tube
lines up with engagement mark (line) on leg. | Slot |
Rotate Headrest Frame 90 degrees and insert |
|
Left Leg into Left Connector of Headrest | Tab |
Frame (Figure 4). | |
Notch in Left Leg must line up with screw | Engagement |
hole for Locking Screw. Install and tighten | |
Locking Screw to fully secure frame assembly | Mark |
together (Figure 4a). |
|
4 Headrest | 4a |
Frame |
|
NOTE: Tug on Leg joints to check security of connections.
5 Fabric Seat: | 5 | 5a |
Locate Pocket on back of Fabric Seat and slip over Headrest Frame (Figure 5).
Lift Footrest Frame, and pull lower pocket of Fabric Seat over Footrest Frame until the bottom of the Footrest meets the bottom of the Fabric Seat pocket (Figure 5a).
NOTE: Make certain the four foot pads are in full contact with the floor before using (Figure 5a). Reinstall Fabric Seat onto Headrest and Footrest Frames.
Fabric Seat
Foot
Pad
PAGE 3
