To Assemble (continued)
6 Toys:
Slide Caterpillar Toy mount into track on outside of right connector (Figure 6).
Slide Flower Toy mount into track on outside of Vibration Unit (Figure 6a).
6
Right
Connector
Track 
6a
Left
Connector
Track
Using Caterpillar Toy
Stage 1 (soothing mode): | 1 |
Set switch to Mode 1 for music and lights. Two songs will play for approximately two minutes each. After the songs have played the standby mode begins. When the Caterpillar is moved or shaken the music reactivates for four more minutes.
Stage 2 (interactive mode):
Set switch to Mode 2 for lights, sounds and songs. A sound followed by a song with lights will activate for approximately ten seconds. After ten seconds, interactive mode begins. When the Caterpillar is moved or shaken the music reactivates for ten more seconds.
To turn OFF, move the switch to the center position.
Using Seat Restraint
Unbuckle Restraining Belt. Position your baby in Bouncer. Place | 1 |
Restraining Belt between legs and buckle into position (Figure 1).
Adjust Restraint Straps for proper fit (Figure 1a).
Buckle
Switch
1a
Restraint 
Straps
Using Vibration
Activate Vibration by sliding switch on Vibration Unit from OFF to ON position.
Care and Maintenance
To Remove the Fabric Seat:
Lift Footrest Frame up and remove lower back pocket of Fabric Seat. Remove Fabric Seat from Headrest Frame.
To Wash Toys and Fabric Seat:
Wipe off Toys with soft cloth and warm soapy water. DO NOT IMMERSE TOYS IN WATER.
Fabric Seat can be machine washed in cold water using gentle cycle.
FCC Information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RADIO AND TELEVISION INTERFERENCE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and the receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
Changes and Modifications not expressly approved by the manufacturer or registrant of this equipment can void your authority to operate this equipment under Federal Communications Commissions rules.
PAGE 4
