Guided Tour - AR1 Receiver | Samson AirLine |
6:Unbalanced output* - Use this unbalanced high impedance (5 - 10 K Ohm) 1/4" jack when connecting the AR1 to consumer
7: Balanced output* - Use this electronically balanced low impedance (600 - 2500 Ohm) XLR jack when connecting the AR1 to professional (+4) audio equipment. Pin wiring is as follows: Pin 1 ground, Pin 2 high (hot), and Pin 3 low (cold).
8:Mute (squelch) control - This control determines the maximum range of the AR1 before audio signal dropout.
Although it can be adjusted using the supplied plastic
screwdriver, it should
normally be left at its factory setting. See the “Setting Up and Using Your AirLine System” section on page 16 in this manual for more information.
9:DC input - Connect the supplied 12 volt 200 mA power adapter here. WARNING: Do not substitute any other kind of power adapter; doing so can cause severe damage to the AR1 and will void your warranty.
As shown in the illustration on the left, the supplied AR1 receiver holder can be used to
ENGLISH
5