Samson AirLine Guided Tour - UR1 Receiver / Rear Panel
ENGLISH
| 1 |
|
| 2 | 3 | 4 |
LOCK | DC INPUT |
|
| UNBALANCED | BALANCED SWITCH | BALANCED OUTPUT |
|
|
| OUTPUT | LINE: |
| |
CABLE |
|
|
|
|
| |
| + | - |
|
| ||
|
|
| MIC: |
| ||
AC |
| CAUTION: |
| MIC LINE | XLR: | |
| USE SAMSON |
| 1 GND | |||
|
| |||||
|
| AC ADAPTOR |
| 2 HOT | ||
|
|
| ONLY |
| POWER RATING | 3 COLD |
|
|
|
|
| ||
| CABLE LOCK: LOOP THRU AND TIE | DC 12V, 1.9W(160mA) |
|
-
Using the strain relief: Gather up a loop of wire and pass it through the strain relief, then pass the adapter plug through the loop in order to create a knot.
1:DC input - Connect the supplied
12 volt 160 mA power adapter here, using the strain relief as shown in the illustration below. WARNING: Do not substitute any other kind of power adapter; doing so can cause severe damage to the UR1 and will void your warranty.
2:Unbalanced output* - Use this unbalanced high impedance (5K Ohm) 1/4" jack when connecting the UR1 to consumer
3:Audio Output Level switch - Sets the audio output level attenuation of the balanced output (see #4 below) to
(mic level). See “Setting Up and Using the AirLine System” on page 16.
4:Balanced output* - Use this electronically balanced low impedance (600 Ohm) XLR jack when connecting the UR1 to professional (+4) audio equipment. Pin wiring is as follows: Pin 1 ground, Pin 2 high (hot), and Pin 3 low (cold).
* If required, both the unbalanced and balanced outputs can be used simultaneously.
8