Top Panel Controls

Master Section

This following section details the master section of the mixer.

21. TAPE IN (RCA jacks) - Stereo line

 

23

24

level input, on RCA connectors,

 

 

 

for connecting the output of

21

22

 

devices such as MP3, CD,

 

computer sound-card, or any

 

 

 

other line level device.

 

 

 

22.TAPE OUT (RCA jacks) - The signal present at this connector is the MAIN bus signal before it has passed through the MASTER level control and graphic equalizer. The nominal output level is -10dBV and the impedance is 100 Ohms.

23.MIX 2 - These line level MIX 2 outputs can be used to drive a second speaker system or connect to a stereo device such as computer sound card, MP3, or recorder. The signal at the MIX 2 jacks follows the MIX 2 level control knob allowing you to set a different level at the outputs.

24.MAIN MIX - The MAIN MIX ¼” jacks can be connected to a power amplifier, powered speaker system, or inputs of a digital recorder. The signal at the MAIN OUT jacks follows the MAIN volume fader.

25.FX SEND (MXP124FX) - The signal present at the FX

SEND output is sent from the FX bus, which is fed from 25

the FX send on the input channels. 26

MON SEND (MXP124) - The signal present at the MON SEND output is sent from the MON bus, which is fed

from the MON send on the input channels.

26.PHONES Output - Connect standard ¼” TRS stereo headphones, 60 to 600 Ohms. The PHONES output level is controlled by the MIX 2/PHONES control.

27.

POWER Indicator - The POWER LED lights up to

27

 

 

indicate that the main POWER switch (located on the

 

 

rear panel) is on.

28

28.

Output Level Meter - The output level meter allows you

 

 

to monitor the level of the signal, which is being sent

 

 

to the MAIN MIX jacks.

29

 

NOTE: To avoid distortion, adjust the MAIN MIX level

 

 

 

 

control so that the 0 indicator LED lights occasionally.

 

15