USB Connectivity (MXP124FX Only)

The MXP124FX has a built-in stereo USB audio interface allowing you to record and playback from a computer using virtually any digital recording software. Setting up your mixer with a computer is a simple procedure that takes just

a few minutes. The following section describes how to connect and setup the MXP124FX with a computer.

1. Connect the MXP124FX to the computer using a standard USB cable (not included).

2. In your audio software, set the input and output device to the

MXP124FX.

3. The audio sent from the MXP124FX to the computer

follows the Main Mix bus.

4. For playback, you can return the

USB stereo signal directly into the main left and right mix bus so that the playback from the PC sums

with the MAIN mix on the console. To hear the USB playback in the MAIN MIX press the TAPE/USB TO MAIN MIX switch.

5.The TAPE/USB TO MIX 2 + PHONES switch is used to assign the USB return to the Mix 2 and headphones bus. This allows you to mix the playback in studio monitors or isolate the playback to a mix zone.

9