I cannot access the Internet in the Client screen.
and 'Password' of the 'Remote Desktop' with those of the host PC.
1)Check if the Hub port LED to which the LAN cable is connected blinks. If not, that indicates that the LAN connection is disconnected. In this case, connect using another LAN cable.
2)Check if the settings of the 'Network' tab of 'Settings' have been properly set up. The default setting is "DHCP". If your network uses a static IP address, select 'Use the following IP address' and then enter the appropriate IP address information.
The contents (video, voice) on the server do not play smoothly on the Client Monitor.
This is because the data is transmitted over the LAN. Check your LAN connection status.
I have connected a digital device such as a digital camera, camcorder or USB memory to the USB port, but they do not work.
This model supports USB devices that support removable disk functions without an additional driver installation. Check if the device you want to connect to is a device that supports the removable disk function without an additional driver installation.
The file list does | 1) | Check the files on the card. If only abnormal files (e.g. 0KByte, broken JPEG) |
not appear. | exist, the files do not appear on the screen. | |
| 2) | The time required to display is determined by the size of the file. Wait a |
| moment. | |
| 3) | Check if the format of the file is supported by the Client Monitor. If the |
| extension of the file has been changed, the file will not be played. | |
Check the following items if there is trouble with the monitor.
Check if the power cord and the video cables are properly connected to the computer.
Check if the computer beeps more than 3 times when booting.
(If it does, request an a service for the main board of the computer.)
If you installed a new video card or if you assembled the PC, check if the installed the adaptor(video) driver and the monitor driver.
Check if the scanning ratio of the video screen is set at 56 Hz ~ 75 Hz. (Do not exceed 75 Hz when using the maximum resolution.)
If you have problems in installing the adaptor (video) driver, boot the computer in Safe Mode, remove the Display adaptor at the "Control Panel → System → Device Administrator" and then reboot the computer to reinstall the adaptor (video) driver.
If problems repeatedly occur, contact an authorized service center.
Q & A
Question
How can I change the frequency?
Answer
Frequency can be changed by reconfiguring the video card.
Note that video card support can vary, depending on the version of the driver used.
(Refer to the computer or the video card manual for details.)
