Samsung AH68-01701V manual Power Lines

ENG

POWER LINES

An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits,

or where it can fall into such power lines

or circuits. When installing an outside antenna sys- tem, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

POLARIZATION

This video product is equipped with a polarized alternating current line plug (a plug having one blade wider than the other.) This plug will fit into the power outlet only one way.

This is a safety feature. If you are unable

to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug.

OUTDOOR ANTENNA GROUNDING

•If an outside antenna is connected to the antenna terminal, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges.

•In the U.S.A section 810 of the National Electrical Code, ANSI/NFPA No. 70-1984, provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire

to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

See the figure below.

ATTACHMENTS

Do not use attachments not recommended

by the video product manufacturer as they may cause hazards.

SERVICING

•Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards.

•Refer all servicing to qualified service personnel.

REPLACEMENT PARTS

When replacement parts are required, be sure the service technician has used replacement parts spec- ified by the manufacturer or having the same charac- teristics as the original part. Unauthorized substitu- tions may result in fire, electric shock or other haz- ards.

	ANTENNA￿
	LEAD IN WIRE
GROUND￿	ANTENNA￿
CLAMP
	DISCHARGE UNIT￿
	(NEC SECTION. 810-20)
ELECTRIC￿	GROUNDING CONDUCTORS￿
SERVICE￿	(NEC SECTION 810-21)
EQUIPMENT	GROUND CLAMPS
	POWER SERVICE GROUNDING￿
	ELECTRODE SYSTEM￿
	(NEC ART 250, PART H)

SAFETY CHECK

Upon completion of any service or repairs

to this video product, ask the service technician to perform safety checks to determine that the video product is in proper operating condition.

DAMAGE REQUIRING SERVICE

Unplug this video product from the wall outlet and refer servicing to qualified service personnel under the following conditions.

a. When the power-supply cord or plug is damaged. b. If liquid has been spilled, or objects have

fallen into the video product.

c. If the video product has been exposed to rain or water

d. If the video product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result

in damage and will often require extensive work by a qualified technician to restore the video product to its normal operation.

e. If the video product has been dropped or the cabinet has been damaged.

f. When the video product exhibits a distinct

change in performance - this indicates a need for service.

HEAT

This video unit should be situated away from heat sources such as radiators, stoves, or other products (including amplifiers) that produce heat.

PREPARATION

4