INSTALLATION METHOD
Drilling a Hole in the Wall
◆Drill a hole of 70mm(3 inch) in diameter to the outside.
◆The drilling should be done at a distance of less than 150mm(6 inch) from the floor facing the indoor unit.
Drain Hose
Less than 
ø70mm
150mm 
(3 inch) (6 inch)
◆Extend the drain hose to the drain hose connected to the drain pan, and fix it with the tape or a cable tie to prevent separation. Then make a covering of it so that water can not flow outwardly.
Piping Material | Vinyl Chloride(Outer diameter ø 16mm/0.63 inch) |
|
|
Insulator | Foamed Polyethylene |
|
|
Drain pan
Band 
Insulation
Drain hose 
Indoor and outdoor connection
CAUTION
1.As the draining is of natural drain type, make the drain hose direct downward.
2.If there is any foreign substance in the drain plate, it may clog the drain pipe. Therefore, be sure to remove the foreign substance inside after installation.
3.After completion of installation, be sure to pour water into the drain pan,
and then check the draining condition.
(There is no problem in draining when the draining is completed within 20 seconds.)
Rat-prevention Cover 
◆The piping of this unit can be connected to the left and rear side.
◆When you hit the area for piping connection slightly with a hammer, a hole is made. - If there is any reason to change connection, fill in hole with rubber cabi slot.
Holes for piping connection (2 points)
Rubber cabi slot
