Heating Your Room
You must select the Heat mode if you wish to adjust the :
◆Heating temperature
◆Fan speed when heating
1 If necessary, press the 
(On/Off) button.
Result: ◆ The power indicator on the control panel comes on.
◆The indoor unit beeps.
IMPORTANT The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:
◆Switched on
◆Stopped
lt will start up normally after three minutes.
2 If the 
is not displayed on the control panel, press the 
button on the remote control one or more times until it appears.
Result: ◆ The indoor unit beeps each time you press the 
button.
◆The air conditioner runs in the Heat mode.
Note You can change modes at any time.
3 To adjust the temperature, press the 
buttons on the remote control or 
buttons on the control panel one or more times until the required temperature is displayed. Possible temperatures are between 16OC and 30OC inclusive.
Result: ◆ Each time you press the 
buttons: - The temperature is adjusted by 1OC.
- The indoor unit beeps.
◆ The air conditioner starts heating, provided that the room temperature is lower than the selected temperature.
◆ For the first 3~5 minutes, the fan may not operate to prevent the cool air from running out of the indoor unit.
◆ If the room temperature reachs the set temperature, the air conditioner stops heating, but the fan is still operating.
◆ The Defrost indicator(
) appears when frost forms on the outdoor unit and disappears automatically after removing frost.
4Select the fan speed by pressing the 
button on the remote control
or | button one or more times until the required setting is displayed : | |||
| Automatic(rotated : | ➔ | ➔ | ) |
| Low |
|
|
|
| High |
|
|
|
Result: ◆ Each time you press the 
button, the indoor unit beeps.
5To control the direction of the air flow, refer to page 16.
Note You can't control the airflow direction when the fan doesn't operate.
