Installing the Hob
EN | Important: Be sure the new appliance is installed and grounded only by qualified | |
| personnel.. | ||
| ||
| Please observe this instruction.. The warranty will not cover any damage that may | |
| occur as a result of improper installation.. | |
| Technical data is provided at the end of this manual.. |
•A device must be provided in the electrical installation that allows the appliance to be discon- nected from the mains at all poles with a contact opening width of at least 3 mm.. Suitable isolation devices include line protecting cut - outs, fuses (screw type fuses are to be removed from the holder), earth leakage trips and contactors..
•With respect to fire protection, this appliance corresponds to EN 60 335 - 2 - 6. This type of appliance may be installed with a high cupboard or wall on one side..
•Drawers may not be fitted underneath the hob.•The installation must guarantee shock protection..•The kitchen unit in which the appliance is fitted must satisfy the stability requirements of DIN
68930..
•For protection against moisture, all cut surfaces are to be sealed with a suitable sealant..
•On tiled work surfaces, the joints in the area where the hob sits must be completely filled with grout..
•On natural, artificial stone, or ceramic tops, the snap action springs must be bonded in place with a suitable artificial resin or mixed adhesive.
•Ensure that the seal is correctly seated against the work surface without any gaps. Additional silicon sealant must not be applied; this would make removal more difficult when servicing.
•The hob must be pressed out from below when removed..10
|
| ||
|
| ||
|
|
|
|