Checking the Digital-Signal Strength
Unlike analog channels, which can vary in reception quality from “snowy” to clear, digital (HDTV) channels have either perfect reception quality or you will not receive them at all. So, unlike analog channels, you cannot fine tune a digital channel. You can, however, adjust your antenna to improve the reception of available digital channels.
Channel
Antenna | : Air | √ |
Auto Program |
| √ |
Channel Manager | √ | |
Name |
| √ |
Fine Tune |
| √ |
Signal Strength | √ | |
Move | Enter | Return |
Signal Strength
OK
Enter 
Return
1.Press the MENU button to display the menu.
Press the … or † button to select “Channel”, then press the ENTER button.
2.Press the … or † button to select “Signal Strength”, then press the ENTER button.
If the signal strength meter indicates that the signal is weak, physically adjust your antenna to increase the signal strength.
Continue to adjust the antenna until you find the best position with the strongest signal.
Press the EXIT button to exit
You can also press the S.STRENGTH button on the remote control to check the signal strength.
Using the R.Surf Feature
This feature allows you to set the TV to return to a particular channel after a certain amount of time. For example, you may be watching a channel when commercials start. You can set the R.Surf to “5 minutes”, then switch channels. After 5 minutes, the TV will return to the original channel. To use the R.Surf feature:
Surf 1:30
1.While you are watching the channel to which you want to return, press the R.SURF button. The “Surf Off” is displayed.
2.Press the R.SURF button again to set the timer in thirty second intervals, up to five minutes.
➢The time will start decreasing while you are setting up the timer, and will reset after 5 minutes has passed or you turn it off.
3.The time you set will begin counting down on the screen. When the time runs out, the TV will return to the channel you were watching when you set the timer.
