DSB-4700F
OPERATING THE RECEIVER
1.1 LNB Setting
You can select the satellite and LNB setting conditions to execute channel search and you can alter the settings for 22KHz tone. The parameters set in this menu are needed for programming the channels for the “Auto scanning” and “Manual scanning”.
The necessary information can be found at your antenna and LNB brochures, or you can ask your dealer.
●Select LNB power supply “On”.
●Select the desired satellite name.
●Select the LNB type (frequency).
●Select the DiSEqC Mode
(Off, DiSEqC A, DiSEqC B, DiSEqC C, DiSEqC D, Tone Burst A, Tone Burst B)
●Select the switch 0/12V (“0V” or “12V”)
If you are using a Positioner, select Positioner DiSEqC1.2 (“Yes” or “No”)
22KHz: In case you are using a dual LNB or two antennas connected to a 22KHz tone switch box, with the 22 KHz tone switch (“On”, “Off” or “Auto”) you can switch between both LNB or antennas.
0/12V: When you use two LNBs or antennas is switched to 0/12V, select what LNB and antenna are used enable or disable. 0/12V terminal is located on the rear of STB.
1.2 Positioner Setting
If you have a DiSEqC 1.2 motorized system which is fully compatible with DiSEqC1.2, then you can take advantage of the DiSEqC 1.2 functions available.
●Select Satellite.
●Select any transponder from above satellites and
check out the Frequency, Symbol Rate, FEC and Polarity.
In case problems arise, ask your dealer.
Sometimes this transponder may not exist due to broadcasting. It is better to select main transponder among them for the desired satellite.
●Select from Menu Mode:
“User” mode : Enables control of basic positioner function recommended for beginners. General user uses “User” mode.
“Installer” mode : This is used to search for the position of a satellite manually.
OPERATING THE RECEIVER
1.2.1 User Mode
●Select Driving Mode:
You have an option to choose the positioner’s movement type: Continuous, Step or Time.
●Select Positioner Slot:
When a Satellite position is set with the positioner which doesn't have enough slots and the default slot number in this menu is bigger than a number of slots in a positioner, Positioner slot in menu can be changed and fit to the number of slot in a positioner for a Satellite.
●Position the antenna with north, south, east and west and use the / / / key to drive motor. key drives to west, key drives to east, key drives to north and key drives
to south.
●If you finished driving of motor, select “Store current Position.” and press OK key, to reset new driving motor.
Note : The level indicated in the “Signal Status” is only for reference. The signal quality may be adequate even though the level indicated is not maximum.
●Go to Stored Position.
When the stored position is reached then screen displays “Stop”, you can now continue with the further operations.
●Select the Calculate Sat Positions to recalculate the satellite position and OK key.
1.2.2 Installer Mode
After checking the positioner’s state, installer should use this menu.
He should set the “Disable Limits” before using User mode.
●Select the Drive Motor West/East and use the / keys to drive motor.
key drives to west and key drives to east.
●Select “Enable Limit”, in order to enable “Set Limit”.
●Select “Disable Limit”, in order to disable “Set Limit”.
●Select “Reset Positioner” and OK key to reset positioner.
DSB-4700F
20 | D I G I T A L | S A T E L L I T E | R E C E I V E R | 21 |
