Samsung DVD-R125 instruction manual Other, Remote Control

HDMI output Jitter

Other

I forget my password for parental supervision.

Checkpoint 1

Checkpoint 2

Checkpoint 3

Check your TV system setup correctly.

Screen Jitter may occur when the frame rate is converted from 50Hz to 60Hz for 720p/1080i HDMI (High Definition Multimedia Interface) Output.

Please refer to the user’s manual of your TV.

Checkpoint 1 Press the button on the front panel of the Recorder for more than 5 seconds with no disc in the DVD recorder.

All settings including the password will revert to the factory settings. Do not use this unless absolutely

necessary. (Note that this function is possible only when no disc is inserted.)

Remote Control

The remote control doesn't work.

Checkpoint 1 Point the remote control at the remote control sensor on your DVD recorder. Allow for proper distance. Remove obstacles between your DVD recorder and the remote control.

Checkpoint 2 Check whether the batteries are empty.

Checkpoint 3 Check for the TV/DVD selection button.

Is it possible to change a subtitle and an audio signal on a recorded disc?

Checkpoint 1 A recorded disc is played with only the subtitle and the audio signal which were selected during recording.

Other problems.

Checkpoint 1

Checkpoint 2

Checkpoint 3

Read the table of contents and then find and read the section describing your problem, follow the instructions given.

Turn your DVD recorder off and on.

If the problem still persists, contact a nearby Samsung service centre.

Additional Information

90- English