ENG-16
C
ONNECTIONS
Connecting to a TV (Progressive)1
Using Component video cables (not included),
connect the COMPONENT VIDEO OUT jacks on
the rear of the DVD-VCR to the COMPONENT IN
jacks of your TV.
2
Using the audio cables, connect from the AUDIO
OUT or LINE OUT AUDIO (red and white) jacks
on the rear of the DVD-VCR to the AUDIO (red
and white) IN jacks of your TV.
Turn on the DVD-VCR and TV.
4
Press the input selector on your TV remote
control until the Component signal from the
DVD-VCR appears on the TV screen.
3
With the unit in Stop mode, set the video output
to P-SCAN by pressing the P.SCANbutton on the
front panel until the Progressive Scan mode
prompt screen appears. Then press ENTER and
progressive will be output.
Note
What is "Progressive Scan"?
Progressive scan has twice as many scanning lines as the interlace output method.
Progressive scanning method provides better and clearer picture quality.
The Component Video jacks only output video from the DVD player. To view video from the VCR, you must have
the Video/Line Out (yellow) jack connected.
Only the 480p output resolution is possible with Component.
To see the progressive video output,
- Consult your TV User’s Manual to find out if your TV supports Progressive Scan.
If Progressive Scan is supported, follow the TV User’s Manual regarding Progressive Scan
settings in the TV’s menu system.
- Depending on your TV, the connection method may differ from the illustration above.
White
Audio Cable Component Cable
(not included)
Red
Red
White
Green
Blue
Red
Red
Green
Blue
01304D_V9700_XAA_Eng1 2/22/07 8:10 AM Page 16