Onkyo TX-SR303E instruction manual Connecting Speaker, Connecting a Powered Subwoofer

Connecting Your Speakers—Continued

Connecting Speaker

1	Strip 3/8" (10 mm) of insu-	3/8" (10 mm)
	lation from the ends of the
	speaker cables, and twist
	the bare wires tightly, as
	shown.
2 While pressing the lever, insert
	the wire into the hole, and then
	release the lever.
	Make sure that the terminals are
	gripping the bare wires, not the
	insulation.

Note:

When speaker set B is turned on, speaker set A is reduced to 2.1-channel playback.

Connecting a Powered Subwoofer

Using a suitable cable, connect the AV receiver’s SUB- WOOFER PRE OUT to an input on your powered sub- woofer, as shown. If your subwoofer is unpowered and you’re using an external amplifier, connect the SUB- WOOFER PRE OUT to an input on the amp.

Powered

subwoofer

LINE INPUT

Note:

Make sure the cable is plugged all the way.

The following illustration shows which speaker should be connected to each pair of terminals.

			Speaker Set A
			Center speaker
Front right	Front left	Surround	Surround	Front right	Front left
speaker	speaker	right	left	speaker	speaker
		speaker	speaker
Speaker Set B

17