First Time
6
7
Use the Down [ ] button to select “Surround,” and then use the Left and Right []/[ ] but- tons to select Small, Large, or None.
Small: Select if the surround speak- ers are small.
Large: Select if the surround speak- ers are large.
None: Select if no surround speakers are connected.
Note:
•If the Front setting in step 4 is set to Small, the Large option cannot be selected.
Press the [SETUP] button.
Setup closes.
TESTING THE SPEAKERS
To test that all of the speakers are working properly,
press the remote controller’s [TEST TONE] but-
ton. The test tone will be output by each speaker in turn and the name of each speaker will appear on the display. To turn off the test tone, press the [TEST TONE] button again.
•If the test tone is not produced by a speaker, or it’s produced by a speaker other than that shown on the display, you may have wired the speakers incorrectly and you should check your connec- tions (see page 17).
•If the test tone is not produced by a speaker and its name does not appear on the display, you may have set the speaker settings incorrectly (see page 32).
33