Onkyo TX-SR303E instruction manual Digital Input Signal Formats

Advanced Setup—Continued

4	Use the Left and Right [	]/[ ]
	buttons to adjust the speaker
	level, and use the Down [	] but-
	ton to select the next speaker.

The level can be adjusted from –12 to +12 dB in 1 dB steps (–15 to +12 dB for the subwoofer).

5	Repeat step 4 so that the level of
	the test tone from each speaker
	is the same.
	Speakers that you set to No or None in
	the Speaker Configuration (page 32) do
	not output the test tone.
6	Press the [SETUP] button.
	Setup closes.
	Don’t forget to turn down the volume if
	you turned it up while setting the levels.

Note:

•A quicker way to adjust the speaker levels is to press the remote controller’s [TEST TONE] button to output the test tone, use the [LEVEL–] and [LEVEL+] but- tons to adjust the levels, and use the [CH SEL] button to select the speakers.

•If the multichannel input is selected (page 35), in step 2, the “3. MultiLevel” menu appears instead of the “3. Level Cal” menu, and you can adjust the level of each channel of the multichannel input regardless of the Speaker Configuration settings.

Digital Input Signal Formats

The following table shows the display indicators for each supported digital signal format.

Format	Display
Dolby Digital
DTS
PCM		PCM

Normally, the AV receiver detects the signal format auto- matically. However, if you experience either of the fol- lowing issues when playing PCM or DTS material, you can manually set the signal format to PCM or DTS:

•If the beginnings of tracks from a PCM source are cut off, try setting the format to PCM.

•If noise is produced when fast forwarding or reversing a DTS CD, try setting the format to DTS.

							TUNING	/ PRESET	MASTER VOLUME
STANDBY/ON
							ENTER
	STANDBY
A SPEAKERS B	TONE	+	STEREO	LISTENING MODE	DISPLAY DIGITAL INPUT	RT/PTY/TP MEMORY TUNING MODE	RETURN	SETUP

							CLEAR
PHONES	MULTl CH	DVD	VIDEO 1/VCR	VIDEO 2	VIDEO 3	TAPE	TUNER	CD

DIGITAL INPUT

1	Press and hold the AV receiver’s [DIGITAL
	INPUT] button for about 3 seconds.
2	While “Auto” is displayed (about 3 sec-
	onds), press the [DIGITAL INPUT] button

again to select: PCM, DTS, or Auto.

DTS or PCM: The DTS or PCM indicator, depending on which format you have set, flashes, and only signals in that format are output. Digital signals in other formats are ignored.

Auto (default): The format is detected automati- cally. If no digital input signal is present, the cor- responding analog input is used instead.

50