Using the detergent and water softener

LOADING THE SALT INTO THE SOFTENER

Always use salt intended for use with dishwasher.

The salt container is located beneath the lower rack and should be filled as follows:

ATTENTION

Only use salt specifically designed for use in dishwashers! All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener. In case of damages caused by the use of unsuitable salt the manufacturer does not give any warranty nor is liable for any caused damages.

Only fill with salt just before starting one of the complete washing programs. This will prevent any grains of salt or salty water, which may have been split, remaining of the bottom of the machine for any period of time, which may cause corrosion.

After the first wash cycle the control panel light expires.

1. Remove the lower basket and then unscrew and remove the cap from the salt container.

Open

2.If you are fi lling the container for the fi rst time, fi ll 2/3 of its volume with water (around 1 liter).

3.Place the end of the funnel (supplied) into the hole and introduce about

1,5 kg of salt. It is Normal for a small amount of water to come out of the salt container.

4. Carefully screw the cap back on.

5.Usually, the salt warning light will be off after the salt container be fi lled with salt.

• The salt container must be refilled when the salt warning light in the control panel comes on. Though the salt container is filled enough, the indicator light may not light may not switch off until the salt fully dissolves.

If there is no salt warning light in the control panel, you can judge when to load the salt into the softener by the cycles that the dishwasher has run.

If a lot of salt is spilt inside the dishwasher run a pre wash program to clan the spillage.

22_ Using the detergent and water softener

DW5000H_DD81-01651A-09_EN (UAE).indd 22

2017-06-08 ￿￿ 3:54:56