1.Open the door and remove all foam, paper packaging, and unnecessary parts.
2.Turn on the circuit breaker you turned off before you began the installation.
3.Open the water supply valve to supply water to the dishwasher.
4.Turn on the dishwasher, and then select and run a cycle.
Check if the power turns on correctly and if there is any water leakage while the dishwasher is operating.
Make sure to check for water leakage on both ends of the water supply line and drain hose CAUTION connector.
5.To install the kick plate, refer to the fi gure below.
1)Install the ‘Felt Lower’ onto the inside of the ‘Kick Plate’.
8 | 4 |
2) Models that are not equipped with the adjustable leg
Big
Install over
Small 96.5mm
Install over 96.5mm
3) Models that are equipped with the adjustable leg
Small
Big
INSTALLING 03
7
7
5
5
Assemble the bracket in the right direction and order as shown in the fi gure.
Installing your dishwasher _19