ç Contents

ç Chapter Contents

218

• The following Windows settings are configured when you run the utility in step 2.

-Turn on media streaming.

This will enable the camera to find the computer to access via

Wi-Fi.

-Turn on network discovery.

This will enable the computer to find the camera.

-Turn on ICMP (Internet Control Message Protocol). This allows you to check the network connection status.

-Enable Universal Plug & Play (UPnP).

This will enable network devices to detect each other automatically.

•Some security software may prevent you from completing the settings as described here. Check the settings of your security software.

Adding a Computer

Add a computer to your list of devices to connect to via Wi-Fi. Follow these instructions when using a Wi-Fi Protected Setup (WPS) compatible access point to establish a push-button connection.

If your access point is not WPS-compatible, establish a connection as described in “Connecting to Access Points in the List” (=222).

• WPS makes it easy to complete settings when connecting devices over Wi-Fi. You can use either Push Button Configuration Method or PIN Method for settings on a WPS supported device.

•Refer to the user guide provided with your access point to check if it supports WPS.

•Be sure to also read the user guide included with your access point.