Samsung FE-R500_XAC Surface cooking, About surface cooking, About the radiant surface elements

surface cooking

About surface cooking

BEFORE COOKING

CAUTION	•	Do not use the glass cooktop surface as a cutting board.
	•	Do not place or store items that can melt or catch fire on the glass cooktop, even
		when it is not being used.
	•	Turn the surface units on only after placing the cookware on them.
	•	Do not store heavy items above the cooktop surface. They could fall and damage it.
	DURING COOKING
CAUTION	•	Do not place aluminum foil or plastic items such as salt and pepper shakers, spoon
		holders, or plastic wrappings on the range when it is in use. The hot air from the vent
		could melt plastics or ignite flammable items.
	•	Make sure the correct surface unit is turned on.
	•	Never cook directly on the glass. Always use cookware.
	•	Always place the pan in the center of the surface unit you are cooking on.
	•	Never leave surface units unattended while using a high heat setting. Boilovers cause
		smoking and/or greasy spllovers that may catch on fire.
	•	Turn the surface units off before removing cookware.
	•	Do not use plastic wrap to cover food. Plastic may melt onto the surface and be very
		difficult to remove.
	AFTER COOKING
CAUTION	•	Do not touch the surface units until they have cooled down.
	•	The surface may be still be hot and burns may occur if the glass surface is touched
		before it has cooled down sufficiently.
	•	Immediately clean spills on the cooking area to prevent a tough cleaning chore later.
	•	If cabinet storage is provided directly above the cooking surface, make sure that the
		items are infrequently used and can be safely stored in an area subjected to heat.
		Temperatures may be unsafe for items such as volatile liquids, cleaners or aerosol
		sprays.

About the radiant surface elements

The temperature rises gradually and evenly. As the temperature rises, the radiant element will glow red. To maintain the selected setting, the element will cycle on and off. The heating element retains enough heat to provide a uniform and consistent heat during the off cycle. For efficient cooking, turn off the element several minutes before cooking is complete. This will allow residual heat to complete the cooking process.

Radiant elements have a limiter that allows the element to cycle ON and OFF, even at the HI setting. This helps to prevent damage to the ceramic cooktop. Cycling at the HI setting is normal and can occur if the cookware is too small for the radiant element or if the cookware bottom is not flat.

18_ Surface cooking

FE-R500_XAC DG68-00295A.indb 18

2010-02-18 �� 11:33:13