Samsung HT-C5950P/XER manual Installing the Speakers on the Tallboy Stand, Connecting The Speakers

Installing the Speakers on the Tallboy Stand

02 Connections

*HT-C5950 only - Front/Surround speakers

1.Turn the Stand Base upside-down and connect it to the Stand.

2.Insert small screws (4x20, For connecting Stand & Stand Base) clockwise into the four holes marked using a screwdriver as shown in the illustration.

!CAUTION

When you use a torque screwdriver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screwdriver- below 15 kg.f.cm)

3.Connect the upper Speaker to the assembled Stand.

4.Insert another large screw (5x15, For connecting Speaker & Stand) clockwise into the hole on the rear of the speaker using a screwdriver.

5.This is the appearance after the speaker is installed.

Follow this steps to install other speaker.

1

3

5

2

Stand

Base

Stand

Speaker	4
Stand

Connecting The Speakers

1. Press down the terminal tab on the back of the speaker.

2.Insert the black wire into the black terminal (–) and the red wire into the

red terminal (+), and then release the tab. Black Red

3. Connect the connecting plugs to the back of the product by matching the colours of the speaker plugs to the speaker jacks.

In case of HT-C5900

Centre Speaker	Front Speaker (L)
Front Speaker (R)	Subwoofer
	SPEAKER IMPEDANCE : 3
Surround Speaker (R)	Surround Speaker (L)

* Refer to page 18 for the speakers of HT-C5950.

English 19