Connections
Speaker Components
(L) (R)
SWA-5000
STAND | SUBWOOFER | TX Card |
FRONT/FRONT TOP |
| |
| CENTER | Wireless Receiver Module Speaker Cable (2EA) |
SCREW (4x20): 8EA
(L)(R)
SCREW (5x15): 4EA
SURROUND | STAND BASE | SPEAKER CABLE |
Installing the Speakers on the Tallboy Stand
1.Turn the Stand Base upside-down and connect it to the Stand.
2.Insert small screws (4x20, For connecting Stand & Stand Base) clockwise into the four holes marked using a screwdriver as shown in the illustration.
!CAUTION
When you use a torque screwdriver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screwdriver- below 15 kg.f.cm)
3.Insert the large screw (5x15, For connecting Stand & Stand Base) clockwise into the hole on the rear of the stand using a screwdriver.
4.Connect the upper Speaker to the assembled Stand.
5.Insert another large screw (5x15, For connecting Speaker & Stand) clockwise into the hole on the rear of the speaker using a screwdriver.
6.This is the appearance after the speaker is installed. Follow this steps to install other speaker.
1 |
Stand Base |
Stand |
3 |
5
2
4
6
Speaker
Stand
