Setup
Initial Settings
1.Turn on your TV after connecting the product. When you connect and turn on the product to a TV for the first time, the Initial Settings screen appears.
Initial Settings
Select a language for the
Български | Hrvatski |
| Čeština | |
|
|
|
| English |
Dansk | Nederlands |
| ||
Eesti |
| Suomi |
| Français |
Deutsch | Ελληνικά |
| Magyar | |
Indonesia | Italiano |
|
m Move " Enter
2.Press the ▲▼◄► buttons to select the desired language, and then press the ENTER button.
3.Press the ENTER button to select Start.4.Press the ▲▼ buttons to select the desired TV Aspect Ratio, and then press the ENTER button. (See page 31)
5.Press the ENTER button again. If the LAN cable is not connected, press the BLUE (D) button on your remote instead to skip a Network Setting here, finish the Initial Settings, and go to the Home menu. For more information about the Network setting, go to pages 37~40. When done, go to Step 6.
✎NOTE
If the LAN cable is connected, the Initial Settings will be finished.6.The Home menu appears. (For more information about the Home menu, please see page 29.)
28 EnglishVideos
Photos
Music
Function | My Devices | Internet | Settings |
d WPS(PBC)
✎NOTE
The Home menu will not appear if you do not configure the initial settings except as noted below.
If you press the BLUE (D) button during the network setup, you can access the Home menu even if the network setup is not completed yet.
If you want to display the Initial Setting screen again to make changes, select the Initial Settings. (See page 40)
If you use an HDMI cable to connect the product to an Anynet+
If you leave the product in the stop mode for more than 5 minutes without using it, a screen saver will appear on your TV. If the product is left in the screen saver mode for more than 20 minutes, the power will automatically turn off.