connections

ATTACHING THE TOROIDAL FERRITE CORE TO THE POWER CORD OF THE SUBWOOFER

Attaching the Toroidal ferrite core to the power cord of the subwoofer helps prevent RF interference from radio signals.

1.Pull the fixing tab of the Toroidal ferrite core to open it.

2.Make two loops around the core with the power cable of the subwoofer.

3.Attach the Toroidal ferrite core to the Subwoofer power cord as the figure

shows and press it until it clicks.

LOOPING THE POWER CABLE AROUND THE TOROIDAL CORE

Lift up to release the

Make two loops around the core

Close the lock.

lock and open the core.

with the power cable. (Start

 

 

winding 5-10cm (2-4in) away

 

 

from the core).

 

 

 

 

AUTO SOUND CALIBRATION (ASC)

For your best sound experience, ASC provides re-positioning and calibrating Air Track and sound devices including the Sub Woofer, by automatically adjusting sound balance considering the distance between devices and frequency characteristics.

1.Place the ASC Microphone at the listening position.

•Please make sure to place the ASC mic on the actual listening point for precise adjustment.

2.Connect the ASC Microphone into the ASC IN jack on the Air Track. The Calibration starts automatically and it may take about 2 minutes.

•If you turn off the Air Track or unplug the ASC microphone before the completion message appears on the display, calibration will be cancelled and incomplete. In such a case, plug the ASC microphone into the ASC IN jack again.

•When the Calibration completes, you can choose the ASC mode by pressing the Sound Effect button on the remote control.

ASC

microphone

▪During the ASC calibration, all other buttons do not work except the power button.

▪ASC will abort with error if you change the set’s position in the middle of ASC calibration.

12