![](/images/new-backgrounds/1311448/31144815x1.webp)
Installing Batteries in the Remote Control
1. Slide the cover out completely.
2. Install two AAA size batteries.
Make sure to match the “+” and
3.Replace the cover.
Remove the batteries and store them in a cool, dry place if you won’t be using the remote control for a long time. The remote control can be used up to about 23 feet from the TV. (Assuming typical TV usage, the batteries last for about one year.)
If the remote control doesn’t work, check the following:
1. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power outage, or is the power cord unplugged?
5. Is there a special fluorescent light or neon sign nearby?
Switching On and Off
The mains lead is attached to the rear of your set.
1.Plug the mains lead into an appropriate socket.
The standby indicator lights up on the front of the set.
2.Press the button on the front of the set.
The programme that you were watching last is reselected automatically.
3.Press the numeric buttons (0~9) or channel up/down ( /
) buttons on the remote control or
buttons on the right side of the set.
When you switch the set on for the very first time, you will be asked to choose language in which the menus are to be displayed.
4.To switch your set off, press the button again.
Placing Your Television in Standby Mode
Your set can be placed in standby mode in order to reduce the power consumption. The standby mode can be useful when you wish to interrupt viewing temporarily (during a meal, for example).
1.Press the POWER button on the remote control.
The screen is turned off and a red standby indicator appears on the front of your set.
2.To switch your set back on, simply press the POWER button, numeric buttons (0~9) or channel up/down (
/
) buttons again.
Do not leave your set in standby mode for long periods of time (when you are away on holiday, for example). It is best to unplug the set from the mains and aerial.
Plug & Play
When the TV is initially powered on, several basic settings proceed automatically and subsequently. The following settings are available.
1.Press the POWER button on the remote control. The message “Plug & Play” is displayed.
2. Select the appropriate language by pressing the | or | button. |
Press the ENTER button to confirm your choice. |
|
|
3.The message “Check antenna input.” is displayed with “OK” selected. Press the ENTER button.
Please check that the antenna cable is connected correctly.