Samsung LE40M9 manual Viewing the Remote Control, Installing Batteries in the Remote Control

Viewing the Remote Control

Selects a target device to be controlled by the Samsung remote control (TV, DVD, STB, CABLE, VCR) (Refer to page 37~41)

Television Standby button

Number buttons for direct channel access

One/Two-digit channel selection

Selects the HDMI mode directly

Selects the TV mode directly

VCR/DVD Functions Rewind, Stop, Play/Pause, Fast/Forward

Volume increase Volume decrease

Temporary sound switch-off

Menu display and change confirmation

Sound mode selection

It displays "Channel Manager" on the screen

Picture effect selection

PIP FUNCTIONS

PIP: Picture-In-Picture On / Off

SOURCE: Input source selection

SWAP: Interchange the main and

sub picture P : Next channel

P: Previous channel

Sound effect selection

SRS TSXT selection

SET: Adjusts 5 separate devices - TV, DVD, STB, CABLE, or VCR.

RESET: When your remote does not work, change the batteries and press the “RESET” button for 2-3 seconds before use.

Available source selection

When pressing this button, a number of buttons on the remote control (e.g.

Selects a target device, volume, channel and MUTE buttons) light up for a few seconds and then turn off to save power. This function is to conveniently use the remote control at night or when dark.

Previous channel

Selects the PC mode directly

This function enables you to load saved photo (JPEG) and audio files (MP3) and to view or play them on the TV.

P : Next channel

P : Previous channel Exit the OSD

Control the cursor in the menu

Use to see information on the current broadcast

Picture freeze

Picture size selection Automatic Power-off

Teletext Functions

Exit from the teletext display

Teletext index

PIP: Teletext hold

SOURCE: Teletext size selection

SWAP: Teletext store

Teletext mode selection (LIST/FLOF)

Teletext sub page

P : Teletext next page

P : Teletext previous page Teletext cancel

Teletext reveal

Alternately select Teletext, Double, or Mix.

Fastext topic selection

The performance of the remote control may be affected by bright light.

This is a special remote control for the visually impaired,

and has Braille points on the Power, Channel and Volume buttons.

Installing Batteries in the Remote Control

1. Lift the cover at the back of the remote control upward as shown in the figure.

2. Install two AAA size batteries.

Make sure to match the “+” and “–” ends of the batteries with the diagram inside the compartment.

3.Replace the cover.

Remove the batteries and store them in a cool, dry place if you won’t be using the remote control for a long time. The remote control can be used up to about 23 feet from the TV.

(Assuming typical TV usage, the batteries last for about one year.)

If the remote control doesn’t work, check the following:

1.Is the TV power on?

2.Are the plus and minus ends of the batteries reversed?

3. Are the batteries drained?

4. Is there a power outage, or is the power cord unplugged?

5. Is there a special fluorescent light or neon sign nearby?

English-6